|
|
| |
System technology: Fast, compact, secure!
|
Benefits of using standardised system packages for commercially available power circuit-breakers
Configuration of the Maxi-PLS compact busbars is simple and fast with standard components.
This technology permits compact, parallel bar arrangement, with positioning of the connections tailored to the respective power circuit-breakers.
Standardised, type-tested connections (to DIN EN 60 439-1):
- From the infeed cable connection of the switch panel
- Via the connections of the power circuit-breaker
- To the distributor busbar for NH fused isolators
 |
Rittal SV-TS 8 enclosure system
Simple baying
- Switch panels divided for transportation purposes.
- Baying connection is created even with fully populated enclosures.
Prepared and ready to install for Ri4Power Form 1 components
- The system attachment to accommodate the Maxi-PLS busbar supports is suspended from the upper enclosure frame and screw-fixed. Made from stainless steel to avoid induction heat.
- TS/PS punched sections with mounting flanges, 23 x 73 mm, are simply located into the vertical adaptor sections and fixed into place. They are used, amongst other things, for fast assembly of Maxi-PLS end supports, T-bar supports and system support rails.
|
|
Three phases connected in parallel
- In the modular system, the "heart" of the Maxi-PLS connection technology is quickly created, for a compact solution with perfect insulation:
- Low-loss connection points.
Easy and compact, with U contact makers.
- Every phase is shielded separately. Isolator chassis for perfectly insulated routing of the connection brackets.
- To fit all standard power circuit-breakers. Pre-assembled connection brackets, ready to install.
|
|
 Without sawing, bending, drilling
For each phase, the U contact maker, isolator chassis and connection bracket form a single unit. Each unit is screw-fixed to the Maxi-PLS compact busbar using a sliding block.. The centre-to-centre spacing of the connection brackets is adjusted with infinite variation to the respective power circuit-breaker. |
|
|
| | |
|
| |
|
| |
