Cable routing and clamping

Cable ducts and accessories

In addition to the DIN punchings, the mounting holes of Rittal cable ducts also have punchings on a 25 mm pitch pattern, completely eliminating the need for any machining. Components are simply screw-fastened into the round holes. The screw heads may be securely covered with an isolator cap for insulation purposes.

Cable ducts and accessories

Cable duct

With special DIN punchings for direct mounting on the enclosure section or on surfaces such as mounting plates. Nominal break points on the bars and on the cable duct base.

Cable ducts and accessories

Isolator cap for screw head

To isolate screw heads e.g. within the cable duct.

Cable ducts and accessories

Cable duct for vertical TS section

For mounting on the vertical enclosure section, on two bayed enclosure sections in the vicinity of baying.

Cable ducts and accessories

Aluminium rivet

For secure assembly of cable ducts and for mounting support rails and punched rails.

Cable ducts and accessories

Cable duct for VX IT, TX CableNet, Data Rack

Cable duct with removable duct cover hinged on both sides.

Cable ducts and accessories

Brush kit for cable duct VX IT

Cut-outs for cable routing at any given positions in the side panel, rear panel, doors, roof and gland plate may be finished off attractively by simply attaching the brush strip.