Section for cable entry, rear for VX, SE
Model No. VX 8618.813
Unlike the section for cable entry, centre, the rear section is mounted directly onto the base opening. In this way, when installing the mounting plate in the rearmost mounting position, the cables may be routed directly onto a cable clamp rail without large bending radii. In conjunction with the cable clamp rail, this enables optimum adjustment between the cable entry and mounting plate.
+ Product description
High level of sealing of cables inserted into the enclosure
For top-mounting on the gland plate and enclosure frame
Extruded aluminium section
Seal: PU foam
Cross-section: 30 x 25 mm
|Protection category IP to IEC 60 529:||
IP 55 if installed correctly
Plug-in sections, incl. foam rubber clamp strip
You will need two pieces per cable entry point.
From an enclosure width of 1000 mm, the base assembly is divided into two sections in the width. Two cable entry points (left/right) may be used.
Enclosure type: VX
Enclosure type: SE
Width: = 1200 mm
|Customs tariff number:||
VX Section for cable entry, rear, for W: 1200 mm
+ Add accessories
– Customers who were interested in this item were also interested in
Baying enclosure system VX25 Basic enclosure
Model No.8286.000Section for cable entry, centre for VX, SE
Model No.8618.803Baying enclosure system VX25 Basic enclosure
Model No.8226.000Mounting plate infill for VX, TS
Model No.4590.700Side panel, screw-fastened, sheet steel for VX
Model No.8185.245Baying block, internal for VX, VX IT
Model No.8617.501Wiring plan pocket of sheet steel for VX, TS, CM, SE, PC, TP pedestal
Model No.4116.000180° hinge for VX
Product data (ZIP)
Rittal does not assume any liability for the topicality of the data downloaded locally on your device.