Base/Plinth
-
VX base system
The best from everything. Our base/plinth system VX can be used in virtually every enclosure application. It bundles the best of the previous Rittal baying functions into a variable modular system that allows you to gain more space with fewer parts, enjoy an easier installation, save more time and experience greater flexibility.
-
AX base/plinth system
The large opening in the base/plinth corner piece enables it to be screw-fastened to the enclosure directly from the front. The clip-in trim panels allow simple, fast access to the base/plinth for individual use, e.g. as a cable chamber.
-
Flex-Block Base/Plinth System
Plastic base/plinth system with metal trim panels for simple and fast, tool-free assembly. Complete base/plinth with trim panels at the front, rear and sides, to suit your enclosure dimensions.
-
TS Base/Plinth
TS base/plinth consisting of front and rear base/plinth components, pre-assembled with corner pieces depending on the enclosure width; select side panels to match the enclosure depth.
-
Cable routing compartments
Cable routing compartment with integrated system hole profile for specific system accessories
-
Base/Plinth, Complete
Complete base/plinth for AE, TP, ES, trim panels at the front and rear, with fitted corner pieces and side trim panels.
-
WM Floor Stand Kit Stainless steel
For mounting wallmount enclosures to the floor in accordance with floormount standards. Stainless steel 1.4301 (AISI 304), 12ga, Brushed Finish.
-
WM Floor Stand Kit Carbon steel
For mounting wallmount enclosures to the floor in accordance with floormount standards. Carbon steel, 12ga, RAL 7035.
-
Accessories for Base/Plinths
Accessories for base/plinths, such as base mounting plates, leveling feet, etc.
-
Base/plinth, stationary for PC, IW
Design matches the housing, height 100 mm, with front projection.
-
Concrete Base/Plinth for CS New Basic enclosures
Concrete Base/Plinth for CS Modular and Basic Housings The base/plinth is made from pre-cast concrete sections that are quick and easy to install on site.
-
Cross member for VX, TS, SE, CM, TP, PC, IW, Blue e+ chiller
To increase stability, the cross members project 138 mm beyond the enclosure base frame at the front and rear.
-
Base/Plinth for FlatBox
For attaching to the existing thread in the base of the FlatBox. There is a cutout at the rear for cable routing.
-
Stabilizer for TS IT
Stabilizer for TS server enclosures. The pull-out stabilizer is quickly and easily retrofitted to the lower frame of the server racks and only extended when necessary.
