Base/plinth TS
-
Base/plinth components, front and rear, 100 mm Sheet steel, for TS, TS IT, SE, CM, TP, PC, IW, TE
Base/plinth component consisting of one trim panel and two pre-configured corner pieces.
-
Base/plinth components, front and rear, 200 mm Sheet steel, for TS, TS IT, SE, CM, TP, PC, IW, TE
Base/plinth component consisting of one trim panel and two pre-configured corner pieces. In 200 mm high base/plinth components, one trim panel is divided into two for cable entry.
-
Base/plinth trim panels, side, 100 mm for base/plinth components front and rear
For mounting between the base/plinth components. At 200 mm height, two 100 mm base/plinth trims may be used. Base/plinth trims may be installed rotated through 90° in order to stabilise bayed base/plinth components.
-
Base/plinth trim panels, side, 200 mm for base/plinth components front and rear
For mounting between the base/plinth components. At 200 mm height, two 100 mm base/plinth trims may be used.
-
Base/plinth components, front and rear, 100 mm Stainless steel for TS, SE
Base/plinth components, front and rear, stainless steel, 100 mm.
-
Base/plinth components, front and rear, 200 mm Stainless steel for TS, SE
Base/plinth components, front and rear, stainless steel, 200 mm.
-
Base/plinth trim panels, side, 100 mm Stainless steel for base/plinth components front and rear
For mounting between the base/plinth components. At 200 mm height, two 100 mm base/plinth trims may be used. Base/plinth trims may be installed rotated through 90° in order to stabilise bayed base/plinth components.
-
Base/plinth trim panels, side, 200 mm Stainless steel for base/plinth components front and rear
For mounting between the base/plinth components. At 200 mm height, two 100 mm base/plinth trims may be used.
-
Levelling component for base/plinth, complete and base/plinth, static
For retrospective installation through the corner piece and levelling of floor unevenness atthe installation site up to a maximum of 15 mm.
-
Transport castors for base/plinth, complete and base/plinth, static
For locating onto the base/plinth corner piece 100 or 200 mm high.
-
Base/plinth trim for base/plinth, complete and base/plinth, static
Base/plinth trim panels in IW/PC design.
-
Filter mat for base/plinth component, vented and base/plinth component, vented, with designer trim panel
Mounting frame including filter mat for the base/plinth trim.
-
Base/plinth baying brackets for base/plinth, complete and base/plinth, static
Required if the 100 mm side trim panels are mounted rotated through 90° for additional stabilisation during the transportation of bayed enclosures. Required per trim panel: 2 pcs.