Enclosures

Compact Enclosures

Enclosure and case systems in a compact design, available in the following variants: compact enclosures AX, plastic enclosures AX and system enclosures SE. Extremely versatile for controller applications with moderate space requirements. Meets the highest standards of corrosion protection with a protection category of up to IP 66. The wall-mounted enclosures offer simple interior installation and flexible cable entry.

Compact Enclosures

AX compact control cabinet

System perfection. The new compact control enclosure AX, offers maximum data quality and consistency in engineering as well as safe and flexible assembly and interior installation.

Compact Enclosures

AX Fiberglass-Reinforced Polyester Enclosures

AX plastic housings, optionally with or without viewing window, are ideally suited for outdoor applications. Numerous mounting domes in the housing offer individual interior installation in 25 mm grid with e.g. chassis and rails.

Compact Enclosures

EL Wall-Mounted Housings

3-part wall-mounted housing with 19” mounting rails and designer glazed door. The swiveling center part offers optimum access to the installed components from the front and rear. The wall mounting part allows cable entry from above and below.

Compact Enclosures

VX SE free-standing enclosure system

Individual carbon steel enclosure with stable enclosure body, two integrated mounting levels, screw-fastened rear panel and door. Roof and sides from a single piece with roll-formed frame. Fully compatible with the VX25 baying system. Enclosure widths...

Compact Enclosures

Wallmounted enclosure

These single door wallmount enclosures can be used for virtually any application. The WM series ensures NEMA protection through a secure locking system, foamed-in-place gasket, and knife-edge sealing surface. Features include a cold rolled steel body...

Compact Enclosures

Wallmounted enclosure for Disconnect

These flange mount disconnect wallmount enclosures can be used for virtually any application. The WM series ensures NEMA protection through a secure locking system, foamed-in-place gasket, and knife-edge sealing surface. Features include a cold rolled...

Compact Enclosures

Wallmounted enclosure Two-door

These double door wallmount enclosures can be used for virtually any application. The WM series ensures NEMA protection through a secure locking system, foamed-in-place gasket, and knife-edge sealing surface. Features include a cold rolled steel body...

Compact Enclosures

SE 8 free-standing enclosure system

Individual sheet steel enclosure with stable enclosure body, two integrated mounting levels, screw-fastened rear panel and door. Roof and sides from a single piece with roll-formed frame. Fully compatible interior installation with the TS 8, enabling...