Manual cutting to length

Features and benefits

Features

The required bar length may be precisely and reproducibly set
Product solution for cutting wiring ducts and their covers to length
Product solution for cutting C rails 30/15 and support rails TH 35/7.5 & TH 35/15 to length
Anodised support surface
Laser-engraved calibration in millimetres and inches

Benefits

For cost-efficient manual length-cutting
Cutting ducts and bars to length is easier than manual sawing
Burr-free cutting to length with eccentric lever, no major force required
Integral finger guard for a high level of operational safety
Low-maintenance with a long service life

Product variants

Product solutions for manual cutting to length

Wiring duct cutter M125

Easily and reproducibly cut wiring ducts and covers to length.

Explore now

Support rail cutter MC3

Manual cutting of support rails and mounting angles.

Explore now

Easy, burr-free cuts to the required length by hand

Simple, flexible and precise – our product solutions rail cutter MC3 and wiring duct cutter MC125 are used to manually cut C rails, support rails and wiring ducts to the required length.

Accessories

C rails 30/15

For direct installation on the horizontal enclosure section, on the base configuration rail for CM, on the vertical enclosure section via additional assembly components.

Explore now

Spare blade

Spare blade for wiring duct cutter MC125.

Explore now

Support rail TH 35/15

For snap-mounting terminals or other components with a snap-in system to EN 60 715.

Explore now

Other products

Cutting centre Secarex AC 18

Precise and ergonomic cutting of wiring ducts
Partially automated cutting centre
Five DIN rail sizes in one template

Explore now