Section for cable entry, rear for VX, SE
Model No. VX 8618.811
Unlike the section for cable entry, centre, the rear section is mounted directly onto the base opening. In this way, when installing the mounting plate in the rearmost mounting position, the cables may be routed directly onto a cable clamp rail without large bending radii. In conjunction with the cable clamp rail, this enables optimum adjustment between the cable entry and mounting plate.
+ Product description
High level of sealing of cables inserted into the enclosure
For top-mounting on the gland plate and enclosure frame
Extruded aluminium section
Seal: PU foam
Cross-section: 30 x 25 mm
|Protection category IP to IEC 60 529:||
IP 55 if installed correctly
Plug-in sections, incl. foam rubber clamp strip
You will need two pieces per cable entry point.
From an enclosure width of 1000 mm, the base assembly is divided into two sections in the width. Two cable entry points (left/right) may be used.
Enclosure type: VX
Enclosure type: SE
Width: = 800 mm
|Customs tariff number:||
VX Section for cable entry, rear, for W: 800 mm
+ Add accessories
– Customers who were interested in this item were also interested in
Section for cable entry, centre for VX, SE
Model No.8618.801Door stay for VX
Model No.8618.430Section for cable entry, centre for VX, SE
Model No.8618.800Wiring plan pocket of sheet steel for VX, TS, CM, SE, PC, TP pedestal
Model No.4118.000Baying enclosure system VX25 Basic enclosure
Model No.8886.000Section for cable entry, rear for VX, SE
Model No.8618.810Base/plinth installation bracket for base/plinth system VX, sheet steel and stainless steel
Model No.8620.400Baying enclosure system VX25 Basic enclosure
Product data (ZIP)
Rittal does not assume any liability for the topicality of the data downloaded locally on your device.